 |
Xtramus’s multi-G Viscount x4T/x4TB/x4S test carddelivers an extraordinary, complete, affordable layer 2~3 test solution. |
As a powerful Ethernet test card, Viscount x4T/x4TB/x4S supports multi-user operation, multi-stream traffic, and different kinds of frames/packets of almost any required protocol headers, tags andpayload.
Viscount x4T/x4TB/x4S is perfect for the high port density environment, like test lab, QA, and system test applications, supporting the highest port scalability, virtual scalability and protocol coverage.
Specifically designed for NuStreams chassis, Viscount x4T/x4TB/x4S modules support hot swap, multi-user operation, and Rapid- Matrix, a technology that can generate multi-stream traffic simultaneously with different kinds of frames/packets with almost any required protocol headers, tags and payload for each port.
Viscount x4T/x4TB/x4S is classified in the Xtramus’Lord Series of test cards. Lord Series is the fourth generation of cards developed by Xtramus, featured by faster speed and more streams generation ability per port.
Combined with the new NuStreams chassis, Viscount x4T/x4TB/x4S can perform synchronized tests to ensure the test precision. Also, the time consumed for all DUTs’ multi-task testing will be shortened dramatically.
Along with the advanced technology mentioned above, Xtramus also provides several RFC-2544, RFC-2889, RFC-3918 test suits adaptable for this card, such as NuApps-Dashboard, NuApps-RFC and so on. Xtramus’ Lord series can test the network equipments in conformance, performance and stress tests.
· Support 10G/5G/2.5G/1G/100Mbps(Full Duplex only) Ethernet test equipment
· Stream based wire-speed layer 2~3 traffic generation
· Wirespeed hardware based traffic generation and analysis
· More streams generation ability, up to 256 streams per port
· Extensive header variation and expanded random packet length
· RFC 2544/2889/3918 test suite
· High-precision performance measurement of throughput, latency,loss, sequence and mis-ordering error
· Remote management of test points
· Real-time statistics for each port, including transmitted/received frames for VLAN, IPv4, IPv4 fragment, IPv4 extension , ICMP, ARP, total bytes/packets, CRC, IPCS error, oversize and undersize frames
Model | Viscount x4T | Viscount x4TB | Viscount x4S | ||||||||||
PHY | Marvell | Broadcom | Marvell | ||||||||||
Interface | 4 Multi-G RJ45 ports | 4 Multi-G RJ45 ports | 4 SFP+/SFP ports | ||||||||||
Speed & Mode | 10G/5G/2.5G/1G/100Mbps(Full Duplex only) | 10G/5G/2.5G/1G/100Mbps(Full Duplex only) | 10G/5G/2.5G/1Gbps | ||||||||||
Frame Length | Tx Packet Length: 64 ~ 16Kbytes | ||||||||||||
Payload | · Burst Mode:User-defined pattern, User-defined raw data, Random · Rapid-Matrix Mode: User-defined pattern: Byte Increase/Decrease, Word Increase/Decrease, 32'0 32'1, 64'0 64'1, Random. (Bit is presented by 0 or 1. 8'0 means 8-bit 0, 8'1 means 8-bit 1.) | ||||||||||||
Data Integrity/ Sequence | · Standard CRC check · Sequence miss check and frame loss checked by X-TAG | ||||||||||||
Error Packet Generation | CRC (Good/Bad/None), Undersize, Oversize, Alignment Error, Dribble Error, IP Checksum Error | ||||||||||||
Hardware Counters | Port-based Statistics Counters | ||||||||||||
Tx Counters per Port | Frame Count, Byte Count, Pause Frame Count, Collisions, Single Collision, Multiple Collision, Excess Collision, Tx ARP/ICMP Request/Reply | ||||||||||||
Rx Counters per Port | Valid Rx Frame Count, Valid Rx Byte Count, Broadcast Frame Count, Multicast Frame Count, Unicast Frame Count, Pause Frame Count, VLAN Tagged Frame Count, IPv4 Frame Count, Rx ARP/ICMP Request/Reply, RMON counters, Alignment Error, Dribble Error, Undersize, Oversize, CRC Error, Data Integrity Error, IP Checksum Errors | ||||||||||||
Tx/Rx Rate Counter | Tx/Rx Packet Rate, Tx/Rx Line Rate, Tx/Rx Utilization | ||||||||||||
Streams Counter | Advanced Stream-based Statistics Counters: · Tx Stream Counter Set: up to 256 sets · Tx Counters per Stream: Frame Count, Byte Count · Rx Stream Counter Set: 1 group of 256 sets USC (Universal Stream Counter) per port · Rx Counters per Stream: Frame Count, Byte Count, Frame Loss, Sequence Miss, IP Checksum Error, Latency USC (Universal Stream Counter) are packet filtering rules based on:
| ||||||||||||
Capture Criteria | SDFR (Self-Discover Filtering Rules) technique is able to capture packets by different criteria in either a unique value or a range of values by user-friendly UI.
| ||||||||||||
Transmit Mode | · Single Mode | · Burst Mode | |||||||||||
· Continuous Mode | · Transmitting-by-time Mode | ||||||||||||
Software Support | · NuWIN-RM: Virtual Control Suit for NuStreams Chassis · NuApps-MultiUnits-RM: Simultaneously testing multi DUTs in mass production · NuApps-RFC: Test suit include RFC 2544, RFC 2889, RFC 3918 test(still in development) · NuApps-MFG: Complete multi-DUT mass production testing suit · NuApps-Dashboard: New virtual Control Suit for Lord Series modules only(still in development) | ||||||||||||
Miscellaneous | · Support cross-cardlatency test · Support global command · Different ports can be shared by different users · Support jumbo frame · Support hot swap | ||||||||||||
| Product Brief | PBF_Viscount_x4T_x4TB_x4S_Ver1.0_CHS | v1.0 |  |
| PBF_Viscount_x4T_x4TB_x4S_Ver1.0_ENG | v1.0 | |
